飞轮,flywheel
1)flywheel[英]['fla?wi:l][美]['fla?'wil]飞轮
1.The Application of Acoustic Emission Method on the Damage Detection to Composite Flywheels;声发射法在复合材料飞轮试件损伤检测中的应用
2.Structure Simulative Experiment by Using Acoustic Emission to Detect the Damage and Fracture in Composite Flywheel;声发射检测复合材料飞轮损伤与断裂的结构模拟试验
英文短句/例句

1.flywheel with ring gear有环形内齿轮的飞轮
2.engine balances发动机飞轮上的平衡重
3.Let's have another look at the fly wheel.让我们再检查一下飞轮
4."Is the Flying Cloud arriving soon?"“云飞轮船快到了么?”
5.Ilgner flywheel set伊尔格纳型飞轮装置
6.Free wheels for bicyclesGB/T10642-1989自行车飞轮
7.flywheel mechanical clutch press飞轮机械离合器压机
8.Recommended flywheel bolt torques are:飞轮螺栓的推荐扭力为:
9.Check/correct flywheel alignment.检查/修正飞轮校正。
10.Cold Rolling Forming for Outer Ring of 18-Teeth Single Freewheel of Bicycle;18T自行车单级飞轮飞壳的冷滚轧成形
11.Relating to or equipped with a free wheel.关于或装有飞轮(或自由轮)的
12.Excessive distance between pinion gear and flywheel/drive plate gear.小齿轮和飞轮/驱动板齿轮之间距离过大。
13.We, Fahrenheit Family committee members, will do our best for Fahrenheit and all those other Fahrenheit fans out there like us!我们将会为飞轮海和所有喜欢飞轮海的歌迷做到最好。
14.Design and Simulation of Composite Flywheel with High Speed in Flywheel Battery of Hybrid Electrical Bus;混合动力客车飞轮电池中高速复合材料飞轮的设计与仿真
15.Use hammer and brass drift to tap ring gear onto the flywheel.用锤子和黄铜冲销轻轻敲打环齿轮进入飞轮
16.Turn the handwheel to move the needle bar up to its highest position.转动飞轮,把针杆上升到最高部位。
17.Shipped per Aircraft (S.S/M.S)由…飞机(轮船)装运
18.aircraft gas turbine bearing lubrication飞机燃气涡轮轴承润滑
相关短句/例句

flywheels飞轮
1.Research on magnetic bearing flywheels for attitude control of spacecraft;空间飞行器姿态控制用磁轴承飞轮研究
2.Extended state observer-based fault detection and recovery for flywheels;基于扩张状态观测器的飞轮故障检测与恢复
3)flywheel rim飞轮轮缘
4)flywheel pulley滑轮飞轮
5)flywheel pulley飞轮滑轮
6)WH Wheel车轮,飞轮
延伸阅读

飞轮飞轮flywheel安装在机器回转轴上的具有较大转动惯量的轮状蓄能器。飞轮的作用主要为:①贮存多余和补充欠缺的能量,以保持工作机的转速平稳,改进动力机的工作状况和工作质量。当动力机的输出力矩有周期性波动(如柴油机等),而工作机对转速的平稳度有严格要求时(如并列运转的交流发动机等),飞轮的作用更为重要。②通过让飞轮的转速有较大的升降来贮存和放出能量,以降低动力机所需功率。当工作机载荷有周期变化(特别是有短暂的高峰)而转速允许有较大的变化(如冲压机、锻压机、剪切机等)时,利用飞轮可显著地降低动力机所需功率。例如,一台有飞轮的压力机其电动机功率为50千瓦(kW),如无飞轮,则电动机功率需要600kW才能满足压力高峰扭矩的需要。飞轮的结构一般有板式、辐板式和辐条式3种。为了减轻机械的重量,飞轮一般安装在转速较高的轴上,其质量分布远离旋转轴线。生产线中应用较广的是大轮缘的辐条式飞轮和用结构钢焊接的辐板式飞轮。部分装配式飞轮多用于低速重载的柴油机中。由于飞轮旋转时会产生较大的离心力,所以设计飞轮时要限制飞轮的线速度。铸铁飞轮的周速应小于25~35米/秒,铸钢的应小于50米/秒,盘形铸钢的飞轮周速应小于80米/秒。
一本道色综合手机久久 日本在线加勒比一本道 一本道加勒比久在线dvd